During the use of the ribbon loom, there are often difficulties of that kind. Here are the difficult problems and solutions that will be caused by the operation steps of the ribbon loom.
一、The density of the weaving layer of the loom does not meet the requirements.
Because the weaving density of the ribbon loom is related to the number of weaving spindles, the number of single anchors per spindle, the aperture, pitch, and weaving angle, the number of spindles, the number of single anchors, and the aperture are always the same. The larger the pitch weaving angle, the lower the weaving density. , Check the braiding pitch and braiding angle, if it is not good, adjust it immediately, check if there are roots, missing strands, and small apertures, it should be repaired or disassembled immediately, and the number of spindles, root type, aperture braiding pitch, and core braiding angle are in harmony with each other
二、The density of the weaving layer of the ribbon loom is uneven, and the strands are different in tightness.
The supporting force of the strands of the ribbon loom is out of control. The manufacturer of the vertical loom suggests that if the plastic spring is missing due to long-term fatigue during disassembly, the supporting force of each strand must be adjusted at this time.
三、The weaving pitch of the ribbon loom is uneven.
Too few electromagnetic coils on the traction sheave lead to unstable matching between the transmission ratio of the towing spindle and the line speed of the traction rope Properly increase the number of turns of the cable on the traction sheave, adjust the speed between the two to be stable, and the braid layer has holes, The wire strands are disconnected, the supporting force of paralleling wires is not uniformly controlled, the coiled wires are piled up and cross the wires, the paralleling wires are arranged unevenly, the supporting force of the spindle is not adjusted evenly, and the wire strands are not uniformly tight.