- Before the high-speed knitting machine is turned on, check whether there is any abnormality in each part of the server, fill the lubricating parts with lubricating oil as required, carry out an empty run, and wear protective equipment.
- The high-speed braiding machine passes the wire knot through the guide wheel to the bottom of the flower pot and weaves the electrical conductor, and then winds it on the winding reel through the traction pulley, and after it is fixed, it starts to drive.
- After each shift is parked, the dust, oil stains, and disconnected ends of the wheel slide rail surface, curve groove, left and right spindles, and swing rods should be cleaned in time.
- When the equipment is running, pay attention to the observation of the equipment, and often check whether the lubricating oil can successfully reach the lubrication point from the pipeline. The rotating member of the lower swing arm support frame must be filled with unsalted butter and must be filled with unsalted butter after every 120 hours of operation.
- As for the operating components of the equipment that cannot be covered by the automatic lubrication system, lubricants should be added manually. Pitch diameter interchangeable gears, telescopic gears, and traction belt gears and racks should be greased once per shift; the polished rod of the cable arrangement should be coated with industrial motor oil several times per shift; At the oil injectors of the seated bearings on both sides of the positive shaft sleeve of the line, oil should be supplied once per shift.
- If an unknown shutdown occurs, it can be cleared according to the alarm flashing light signal generated on the “Fault Alarm” interface; if there is often a shutdown without an alarm at the same time as the oil pump alarm setting time, the oil pump and oil passage should be checked Is everything normal; if it is found that the lubricating oil cannot reach the lubricating point, it must be fault detected before it can be restarted.
- During the operation of the equipment, it is not allowed to replace the hanging wheels. Always pay attention to whether the equipment is running normally. car, ask the maintenance staff to help deal with it and then drive again.
- At the end of the work, disconnect the main power supply, clean the work site, remove the wool and dust on the bottom of the flower pot, wipe the equipment everywhere, store the remaining hanging wheels in a designated place, place them neatly, and fill in the process card And various forms and records, do a good job in shift work.
