What are the types and causes of braiding machine waste? Let’s introduce it in detail below.
一、The relative density of the braided layer does not meet the
Because the braiding density is related to the number of braiding spindles, the number of each spindle, the outer diameter, the pitch, and the editing angle, the number of spindles, the number of spindles, and the hole diameter will not change. The more pitch braiding angles, the smaller the braiding density. Check the braiding nodes. Pitch and braiding angle, correct any problems in time, check whether there are any missing roots, missing strands, and small holes, which need to be replaced in time, maintain the coordination between the number of spindles, root type and hole diameter, braiding pitch, braiding angle, and the relative density of the braiding layer Uneven strands are of varying tightness and looseness.
二、The strand tension of the braiding machine is out of control
Replace the torsion spring that has lost elasticity due to long-term use fatigue and adjust the tension of each strand.
三、Uneven braiding pitch
The number of turns of the cable on the traction wheel is too small, resulting in an unstable pairing of the rolling spindle speed ratio and the traction line speed. Appropriately increase the number of turns of the cable on the traction wheel, and adjust the speed between the two to be stable. There are holes and scarred strands in the braid. Caused by breakage, the tension of the changing lane is unevenly controlled, the coil has deposits and crosses the line, the changing lane arrangement is uneven, the spindle tension is not adjusted evenly, the thread strands are unevenly tight, and the maintenance method is unreasonable when the thread strands are disconnected. Adjust the lane tension and adjust the nail tension.
The high-speed stainless steel wire braiding machine is a kind of stainless steel wire knitting equipment. It mainly uses the spindle to make a left-right circular motion at a uniform speed along the guide mechanism to weave the stainless steel wire into the rubber hose body and the rubber and plastic insulation board body according to the rules. The raising layer is used to increase the pressure of the pipe body. This equipment is mainly used in weaving industries such as rubber hose bodies, rubber and plastic insulation panels, and pipe body protective layers.