- Before starting the high-speed knitting machine, check whether there are any abnormalities in all parts of the knitting machine. Fill each lubricating part with lubricating oil as required, conduct an air-open operation, and wear protective equipment.
- After the wire is tied through the tower wheel to the bottom of the flower pot and braided to the conductor, it is then wound onto the reel through the traction pulley. After being fixed, start driving.
- After each shift, the dust, oil stains, and broken joints on the wheel slide rail surface, curve groove, left and right spindles and swing rods should be cleaned immediately.
- When the knitting machine is running, pay attention to the equipment and frequently check whether the lubricating oil can successfully reach the lubrication point from the pipeline. The rotating components of the lower swing arm support frame must be filled with salted butter and must be filled with salted butter after every 120 hours of operation.
- All operating components of the equipment that cannot be touched by the automatic lubrication system should be lubricated manually on a regular basis. The pitch diameter interchangeable gears, telescopic gears, and traction belt gear rack parts should be added with industrial grease once per shift; the main rod of the cable arranger should be filled with industrial engine oil several times per shift; the main rod of the cable arranger should be filled with industrial engine oil And the spherical bearing injectors on both sides of the winding positive bushing should be oiled once per shift.
- If an unknown shutdown occurs in Xuzhou Qixing Machinery Co., Ltd., corresponding clearance can be made based on the alarm flashing light signal generated on the “Fault Alarm” interface; if the same shutdown without alarm occurs in the oil pump alarm setting area, You should check whether the oil pump and oil passage are normal; if you find that the lubricating oil cannot reach the lubrication point, you must check for a fault before restarting.
- During the operation of the high-speed knitting machine, the hanging wheels are not allowed to be replaced. Always pay attention to whether all parts of the equipment are running normally. Operators are not allowed to leave their posts without authorization or let people without work certificates operate. If the equipment malfunctions, Stop the car immediately, ask maintenance staff to help handle it, and then start it again.
- After the work is completed, turn off the main power supply, clean the work site, remove the lint and dust on the bottom of the flower pot, scrub all parts of the equipment, store the remaining hanging wheels in a designated area, place them neatly, and fill in the process card and various forms and records to complete the handover work.
