The fully automatic rewinding machine has copper wire, aluminum wire, thin iron wire, plastic aluminum wire, and plastic copper wire rewind on the reel. It is an auxiliary machine for the group outlet of the wire generator unit (extruder) and the stranding of the copper stranding unit.
The fully automatic rewinding machine has special accessory equipment for winding copper wire, aluminum wire, thin iron wire, electric wire, and other raw materials.
The fully automatic rewinding machine has copper wire, aluminum wire, thin iron wire, plastic aluminum wire, and plastic copper wire rewind on the reel. It is an auxiliary machine for the group outlet of the wire generator unit (extruder) and the stranding of the copper stranding unit.
After the aluminum wire (copper wire, thin iron wire) is installed by the pay-off machine (or construction pay-off tower, etc.), it can be directly rewound on the reel (i.e., the wire wheel), and the torque motor is started for winding. The aluminum wires are swayed in a small way so that the aluminum wires are arranged rhythmically on the plate.
When the fully automatic rewinding machine performs rewinding (rewinding), the tightness in the construction pay-off equipment is adjusted according to the cable diameter, so that the torque controller is adjusted to the appropriate gear, so that the rewinding function of the winding wire is normal. cable. If the construction pay-off equipment is too tight, it will easily break. If it is too loose, the aluminum wire wound in the coil will be broken before the next process is produced.
Xuzhou Qixing Machinery Co., Ltd. pointed out that when the rewinding machine is rewinding (rewinding), it is necessary to pay attention to the tightness of the V-belt between the motor and the winding shaft wheel so that the V-belt has a certain deviation to ensure that the aluminum wire (copper wire, Thin wire) does not break when being wound.
The assembly plate adopts hydraulic transmission system equipment. When assembling the plate, tighten the hydraulic rocker and raise the hydraulic lever to gradually raise the backing plate so that the plate hole matches the top cone wheel. At this time, rotate the movable top cone rocker to push the movable top cone into the plate hole. After the plate is assembled and fixed, tighten the clamping nut to prevent rolling.
When removing the pan, proceed the same as assembling the pan.
