The mesh tube knitting machine mainly adopts more high-precision processing and assembly line expertise and adopts motor soft starter control to further increase the transmission ratio. It also increases the size of the yarn tube and increases the length of time the yarn tube can be used at one time. The spindle relies on the spindle belt drive. The application spindle belts of the mesh tube braiding machine spinning machine also include cotton webbing and rubber strips. The cotton weaving spindle belt of the mesh tube knitting machine has large flexion and extension, and the use cycle is short.
The rubber material spindle belt transmission device of the mesh tube knitting machine is stable, has low vibration, low noise, energy saving, and environmental protection, and has a long service life, but the price is relatively high. Ribbon looms are advancing with the times. Replacing cotton woven ribbons with rubber material spindle ribbons is a development direction and should be promoted and marketed. Therefore, the quality of the yarn tube is very critical to the application of the spindle. It is necessary to choose yarn tubes made of high-quality raw materials (such as ABS, PC, and PP). The mesh tube knitting machine should improve the maintenance of replaced yarn tubes in daily life, and it is also necessary to resolutely remove deformed and damaged poor yarn tubes immediately. If poor quality or deformed and damaged bobbins are used, the unevenness of the spindle will inevitably increase, the load on the spindle roller bearings will increase, and the service life of the spindle will be reduced.
The curved surface of the three-dimensional braiding machine bobbin and spindle should be evenly sealed, and its sealing surface should be no less than 85% to ensure reliable, synchronous, and smooth operation of the bobbin and spindle integration. Yarn bobbins generally require maintenance and inspection for more than half a year, including:
- Elimination: Remove silk waste, flying flowers, and dust, and remove waste silk waste and accumulated waste in the “Super Sky Eye”.
- Set the spindle: Use a standard spindle to set the yarn tube and check the height (±1.0mm) and bottom diameter (0.05-0.15mm).
- Test tube: spindle speed 300 rpm/K line chart, estimate or feel that the amplitude of the upper end of the yarn tube is ≤0.15mm and the lower end is ≤0.25mm (180-190mm yarn tube). The mesh tube braiding machine also removes poor yarn tubes that are deformed, bent, rough on the surface, and scratched.