High-speed braiding machines for wires and cables generally consist of a server and an auxiliary machine. Through the cooperation between the server and the auxiliary machine, simple horizontal and vertical needles, ingot needles, etc. can be programmed. The auxiliary machine is mainly used to weave threaded edges to make the fabric elastic. The jacquard function is carried out in the server part. You can use the one-by-one, two-by-one and three-by-one row needle plates and the narrowing triangle dial in the engine to perform tuck, empty rack, and two-color jacquard, and use wooden needles to transport The electromagnetic coil is used for knitting techniques such as mesh knitting, or through the cooperation of the front and rear needle beds, weaving into horizontal and vertical needles, ingot needles, four-flat needles, double-plate jacquard needles and other embroidery methods. The front needle bed can also be operated independently. Weaving into various techniques such as loops, empty frames, mesh, etc.
The key to the high-speed braiding machine for wires and cables is the relatively high-tech production and processing line, which uses soft starter operation to further increase the transmission ratio. In addition, it can also increase the size of the yarn tube and improve the one-time use of the yarn tube. time also. The spindle bearing is driven by the spindle belt drive system. The spindle belts used in the spinning machines of high-speed braiding machines for wires and cables also have cotton webbing and sealing strips. Cotton spindle belts have a large tension in network knitting machines and have a short use cycle.
The rubber material spindle belt transmission device of the mesh textile machine is stable, has small vibration, low noise, is energy-saving and environmentally friendly, sturdy and durable, but is more expensive. As time goes by, replacing cotton woven spindle belts with rubber material spindle belts is the development trend of cotton woven spindle belts, and its brand promotion is a matter of time. Therefore, for the application of textile spindles, the quality of the yarn tube is particularly important. For yarn bobbins made of high-quality materials (such as ABS, PC, PP, etc.), high-speed wire, machine, and cable braiding machines need to maintain and replace yarn bobbins in daily work and also need to decisively and immediately eliminate deformation and damage of defective bobbins. If poor quality or deformed bobbins are used, it will inevitably increase the unevenness of the spindle, increase the load on the spindle roller bearings, and shorten the use cycle.
The curved surfaces of the bobbin and spindle of the three-dimensional weaving machine should be evenly sealed, and the sealing surface should not be less than 185% to ensure that the integration of the bobbin and spindle is reliable, consistent, and stable. Generally, bobbins need to be cleaned for most of every year, including:
Elimination: Eliminate silk waste, flying flowers, and dust, and eliminate waste and waste accumulation in the “Super Sky Eye”.
Nesting: Use a standard spindle to sleeve the yarn tube and check the hole height (±1.0mm) (0.05-0.15mm).
Test tube: Spindle speed 1800O/K line diagram, the upper amplitude of the measured or touched yarn tube is ≤0.15mm, and the amplitude of the middle and lower part is ≤0.25mm (180-190mm yarn tube). Then replace the wire and cable high-speed braiding machine to remove improper yarn tubes that are deformed, bent, rough, dry, or scratched.
