High-speed knitting machine maintenance inspection content:
- Check whether the oil in the main chassis is within the specified range. Take out the oil probe to ensure that the remaining oil is in the middle of the two lines, but not too much to prevent grease from spraying out.
- Check the grease of the stepless speed regulator, which can be estimated by the oil mirror. If it is less than half of the oil mirror, add grease.
- All gear shaft parts of the machine should be properly lubricated and maintained once a week.
- The main rod part of the polished rod cable organizer should be properly lubricated and maintained once a week.
- Please make sure there are no obstacles within the equipment’s position range, and check it at any time.
- Tighten the screws in the machine’s transmission system and connection parts to prevent loosening from affecting the machine’s operation, and inspect it once a week.
- Before the actual operation of the machine, it should be run at a low speed for about 5 minutes and then increase the speed.
Routine maintenance methods of high-speed knitting machine:
- Use safety inspections to check whether the core process components and tightening connections of each piece of equipment are loose, and tighten loose parts in time.
- Purchase standard tightening joints from designated factories and establish an inspection-centered safety inspection system.
- Unify the tightening procedures of standard parts to minimize under-tightening or over-tightening, which may cause potential failures or reduce the service life of tightened parts.
Safe operating conditions for high-speed knitting machines:
- The motor adopts frequency conversion control, and the stepless speed makes it easy to control the speed ratio and can also be maintained under heavy load.
- Standardized parts replenishment and after-sales service guarantee also provide a strong guarantee for the stable operation of your knitting machine.
- Installing a hanging industrial porcelain eye (aluminum trioxide) at the outlet point of the spinning group to replace the hole-breaking work spinning is an effective structure, making it easier to replace the bobbin and optimize elasticity.
- The fully automatic yarn-breaking and power-off equipment of the knitting machine is convenient and accurate. When the core package is used or disconnected, the machine will automatically stop running. Therefore, the machine can be run safely without anyone actually operating it to enhance production volume and control costs.
- The high-quality parts and effective mechanism of Xuzhou Qixing Machinery Co., Ltd. make the machine run longer and have a longer service life.
- The humanized design is simple to operate and the daily maintenance of the equipment is convenient.
- It is not easy to break or damage the surface of the raw material during weaving. The knitting machine is of high quality. For example, if there is a core-spun product, automatic feeding can be used to send out the appropriate amount regardless of whether the core is large or small.