When any equipment is in use, some maintenance matters often occur, and on such machinery and equipment, there are some parts that require special attention. For braiding machines, the weft completion sensor and the weft break sensor are things that require special attention. Therefore, Xuzhou Qixing Machinery Co., Ltd. will introduce to you the daily maintenance methods of these two sensors.
Weft completion sensor: The braiding machine manufacturer recommends clearing the detector cover on time (once every four hours). When fiber laser cutting is running, ensure that the white light is always on. The detector is designed according to the basic concept of an infrared sensor. The eye-catching lighting will Seriously affect the characteristics of the sensor.
Even if there is only sunlight nearby, the detector may not be able to work if the surface of the spindle is bright. The purpose of the braiding machine manufacturer is to avoid using aluminum yarn tubes or black and gray yarn tubes. The black cotton yarn will make the machine The detector is not working.
Weft broken sensor: During the normal operation of the ten-shuttle circular loom, when the warp is broken due to external force, the sensor detects the signal and sends it to the controller to control the circular loom to stand by if the warp breaks.
The manufacturer of the knitting machine recommends not to switch on and off the machine automatically: run the light-emitting device to make the yarn tube run under the sensor, and quickly tear off the warp manually to make the steel ball enter the detection range of the sensor. At this time, if the red indicator light of the sensor does not light up, The sensor position should be adjusted until the red indicator light comes on or the sensor should be removed.