Some components of the braiding machine, such as the spindle support frame, sliding seat, etc., must ensure the accurate distance between the sliding seat and the lower spindle braiding line after maintenance and disassembly or when adjusting and reinstalling new parts. It is recommended to first place a sliding frame and the attached upper spindle to run on the sliding wheel, so that when the lower weight braiding line is led from the swing rod to the manual knitting point, it will not be hooked or disconnected by the sliding frame.
When the braided wire enters or exits the slot on the sliding wheel track, its distance to the edge of the upper spindle sliding frame must be basically the same. The adjustment of the distance can be accomplished by switching the gear rack forward or backward by one or more gears. If you cannot adjust the distance accurately by moving one tooth, you can adjust it according to the following steps: loosen the five fixing screws on the internal gear. Since the buried hole is oval, you can complete the sliding frame by moving the internal gear. Adjust and tighten the screws after adjusting in time.
Matters needing attention in the maintenance and adjustment of high-speed braiding machine parts:
- Check whether the grease in the main box of the braiding machine is within the required area. Take out the oil probe and lower it to ensure that the oil level is between the two lines, but not too much to prevent the grease from spraying out;
- Check the grease in the turbocharger box of the braiding machine, which can be estimated by the oil mirror. When the oil mirror is less than half of the oil mirror, the grease must be replenished in time. (Do not use the oil lens too high when filling);
- The impeller and pivot part of the braiding machine should be lubricated before each shift starts and the countertop should be wiped clean to prevent debris from blocking the spindle;
- The gear parts of the entire drive system of the braiding machine should be properly lubricated and maintained;
- The main rod part of the glossy cable arrangement of the knitting machine should be properly lubricated and maintained;
- Make sure there are no obstacles in the position area of the braiding machine equipment;
- Tighten the screws in the drive system and connection parts of the braiding machine to prevent loosening from affecting the operation of the equipment;
- Before actual operation of the braiding machine, it should be run at low speed for about 5 minutes and then increase the speed.