There are many factors related to the frequent disconnection of the braiding machine. The operation of the machine must be stable and vibration-free. The wire path must be smooth and flexible. Generally, the lower ingot makes it easy to break the wire. Check whether the swing rod, bearing, and guide wheel are flexible, the relative height of the weaving mold, whether the mold shell is damaged, and the tensile strength of the weaving wire are also closely related. These!
High-speed knitting machine maintenance inspection content:
- Check whether the lubricating oil in the main chassis is within the required standard, take out the oil probe and lower it to ensure that the remaining oil is in the middle of the two lines, but not too much to prevent the lubricating oil from spraying out.
- Check the lubricating oil of the turbocharger box, which can be estimated by the oil mirror, and when it is less than half of the oil mirror, the lubricating oil should be filled. (When replenishing, the oil lens should not be too high)
- The centrifugal impeller and the shaft center should be lubricated before the start of each shift and the countertops should be cleaned to prevent dirt from getting stuck and falling into the spindle.
- All gear shaft parts of the machine should be properly lubricated and maintained once a week.
- Carry out proper lubrication and maintenance on the polished rod part of the gloss cable arranger once a week.
- Within the range of equipment posture, it must be confirmed that there are no obstacles to check at any time.
- Tighten the screws of the machine’s transmission system and connecting parts to prevent loosening from affecting the machine’s operation and check it once a week.
- Before the machine is actually operated, run it in low gear for about 5 minutes.