High-speed braiding machine maintenance inspection details:
- Check whether the lubricating oil in the main chassis is within the specified range. Take out the oil probe and lower it to ensure that the remaining oil is in the middle of the two lines, but not too much to prevent the lubricating oil from spraying out.
- Check the lubricating oil of the stepless speed regulator. It should be estimated by the oil mirror. If it is less than half of the oil mirror, add lubricating oil.
- All gear shaft parts of the machine should be properly lubricated and maintained once a week.
- The main rod part of the polished rod cable organizer should be properly lubricated and maintained once a week.
- Make sure there are no obstacles within the position range of the machine and equipment, and check anytime and anywhere.
- Tighten the screws in the machine’s transmission part and connection parts to prevent loosening from affecting the machine’s operation. Check once a week.
- Before the actual operation of the machine, run it at a low speed for about 5 minutes and then increase the speed.
Routine maintenance methods for high-speed braiding machine standard parts:
- Use inspection to see if the core process components and tightening joints of each piece of equipment are loose, and tighten loose parts in time.
- Purchase standard tightening joints from designated factories and establish an inspection-centered safety inspection system.
- Unify the tightening procedures of standard parts to minimize under-tightening or over-tightening, which may cause potential failures or reduce the service life of tightened parts.