What are the types and causes of braiding machine waste? Xuzhou Qixing Machinery Co., Ltd. will introduce it below.
一、The relative density of the braided layer does not meet the requirements.
Because the braiding density is related to the number of braiding spindles, the number of each spindle, the outer diameter, the pitch angle, the number of spindles, the number of spindles, and the aperture will not change. The more pitch braiding angles, the smaller the braiding density. Check the braiding pitch. and braiding angle, correct any problems in time, check whether there are missing roots, missing strands, and small holes that need to be replaced in time, maintain the harmony between the number of spindles, root type and hole diameter, braiding pitch and angle, and the density of the braided layer is uneven. Varies in tightness.
二、Tension of thread strands on the braiding machine is out of control
Replace the torsion spring that has lost elasticity due to long-term use and adjust the tension of each strand.
三、Uneven braiding pitch
The number of turns of the cable on the traction wheel is too small, causing the rotation speed ratio of the rolling spindle and the traction line speed not to match. Properly adjust the number of turns of the cable on the traction wheel to stabilize the speed between the two. This may lead to broken strands and changes in track tension. Uneven control, there is the deposit on the winding wire, cross-cutting, uneven track arrangement, spindle tension is not adjusted evenly, thread strands have different tightness, when the thread strands are disconnected, the maintenance method is unreasonable, adjust the track tension, adjust Adjust the nail tension.
The high-speed stainless steel wire knitting machine is a kind of stainless steel wire knitting equipment. It mainly uses the spindle to make a left-right circular motion at a uniform speed along the guide mechanism to weave the stainless steel wire into the rubber hose body and the rubber and plastic insulation board body according to the rules. The raising layer is used to increase the pressure of the pipe body. This equipment is widely used in weaving industries such as rubber hose bodies, rubber and plastic insulation panels, pipe bodies, and protective layers.