The specific content of the maintenance and inspection of the reverse knitting high-speed knitting machine:
- Check whether the lubricating oil in the main chassis is within the required range, take out the oil probe and lower it to ensure that the remaining oil is in the middle of the two lines, but not too much to prevent the lubricating oil from spraying out.
- Check the lubricating oil of the turbine box. It can be estimated by the oil mirror. When it is less than half of the oil mirror, it needs to be filled with lubricating oil.
- All gear shaft parts of the equipment should be properly lubricated and maintained once a week.
- The main rod part of the polished rod cable arrangement should be properly lubricated and maintained once a week.
- Make sure that there is no obstruction within the range of equipment movement, and check it at any time.
- Tighten the screws of the transmission system and connection parts of the equipment to prevent loosening from affecting the operation of the equipment, and check it once a week.
- Before using the equipment, run it in low gear for about 5 minutes before increasing the speed.
Prevention method of reverse knitting high-speed knitting machine:
- Disassemble and replace the new bobbin.
- Part of the yarn is broken or disconnected.
- Alplatin discontinuation or no Alplatinum.
- The core wire is terminated or there is no core wire.
- The power-off main dial is stuck and cannot be returned.
- Check if the sensor is magnetically sensitive.