The high-speed braiding machine is a kind of chain-link fence crocheted from medium-carbon steel wire, stainless steel wire, aluminum profile wire, PVC wire, and plastic-coated wire. It has the characteristics of uniform mesh, smooth surface, unique style, adjustable total width of the mesh, and A spacing size is adjustable, it does not easy to corrode and has a long service life. It has the characteristics of simple hand-made weaving, unique style, and powerful functions.
The high-speed braiding machine has the characteristics of high production and processing efficiency and stable process performance. Using the brand’s servo motor automatic control system, the equipment failure rate is greatly reduced, the characteristics are maintained for a long time, and the cutting and dividing position is more accurate. Part of the reducer: It is a precision-machined planetary reducer-body machine with high wear resistance and low noise.
Key tasks and common problems when starting up the high-speed braiding machine:
- Before starting the high-speed braiding machine, turn on the person in charge of the power supply system and clean the sewage pipes first to prevent residual sewage in the pipes from entering the water storage tank, pump body, and printer nozzle.
- Then use water to wet the warp threads at the weaving edge, steel foil, and healds to loosen the remaining slurry to prevent the remaining hard slurry from polishing and breaking the warp threads when driving immediately.
- Connect the switching power supply circuit of the high-speed braiding machine, plug in the circuit control board, open the water supply tank power supply system valve, test the power supply and water pressure, and observe whether the water and electricity are normal.
- Adjust the warp strength well, and turn the machine tool spindle bearing diameter gauge by hand to check whether the eruption, beating up, heavy lifting, etc. are normal.
- If the variety and model of raw silk must be changed, the weft wire and appropriate let-off and unwinding transmission gears can be replaced, and the weft density can be changed.
- If the steel foil healds of the high-speed knitting machine have severe sizing, causing warp filaments to fluff, etc., you can manually shake the warp wires 3 to more than 10 centimeters past the weaving mouth and then try driving again depending on the specific situation.
- If the above important tasks are done well and everything is normal after checking, you can start the operation process according to the normal operating procedures.