During the process of using the high-speed knitting machine, did you find that even after the high-speed knitting machine was lubricated and treated, it was still not easy to use, and the equipment was not wet and rusted? It was cleaned and cared for and stored for several months before being used. The equipment was found to be very astringent. Even if the machine head and track were lubricated with oil, it was still very astringent. It was not smooth when it was used. What should I do now?
It is very convenient and fast to regularly maintain the high-speed knitting machine to remove the floating hair and oil stains in the machine head. It is very convenient and quick to use a children’s toothbrush to brush out the floating soft hair so that the hair cannot be pasted inside the internal structure. Normally, you don’t need to spray a lot of sewing machine oil on the internal structure of the machine head immediately.
Spray sewing machine oil on a clean towel, and then use oil paper to remove oil stains on the head of the cable knitting machine, so that the parts of the machine head can feel “moist, refreshing and not greasy”, and the upper, lower, left, and right tracks are all cleaned the same.
Hook and remove the decorative strip Take out the long crochet needle from the common toolbox and pay attention to the front and back sides of the decorative strip. Then, turn the hook head down and go deep under the edge of the decorative strip. Slowly pull out the decorative strip (from the left or from the right).
Regularly maintain the high-speed knitting machine to remove the floating hair and oil stains in the needle. You can take out the needle, spray sewing machine oil on the needle to clean it, and then clean it until it becomes lubricated and becomes slippery or slightly oily.
The track of the machining center is the high-frequency friction area of the high-speed knitting machine, and it is an important part of daily cleaning and maintenance. Use clean oil paper sprayed with sewing machine oil to clean the track again, without the occurrence of black oil drying and hard dirt. If the equipment is not lubricated and clean, it is impossible to weave freely and smoothly. Don’t be arrogant in victory or discouraged in defeat. Sharpen your knife and don’t cut firewood by mistake. Please pay attention to the cleaning and maintenance of the machine. For those who are going to put it aside for a while and then take it out for use, it needs to be reconfigured.
The overall design of the high-speed knitting machine with fences on the track, the overall design of the fence is to cooperate with other various attached heads to carry out intelligent extended-hand knitting applications. When cleaning, be careful not to wipe the black oil stains into the gaps, so as to ensure that the oil is clean and tidy on the head and track, and the effect is guaranteed to be moist, refreshing, and non-greasy.